50 lines
2.5 KiB
Plaintext
50 lines
2.5 KiB
Plaintext
[[system-config-tcpretries]]
|
|
=== TCP retransmission timeout
|
|
|
|
Each pair of nodes in a cluster communicates via a number of TCP connections
|
|
which remain open until one of the nodes shuts down or communication between
|
|
the nodes is disrupted by a failure in the underlying infrastructure.
|
|
|
|
TCP provides reliable communication over occasionally-unreliable networks by
|
|
hiding temporary network disruptions from the communicating applications. Your
|
|
operating system will retransmit any lost messages a number of times before
|
|
informing the sender of any problem. Most Linux distributions default to
|
|
retransmitting any lost packets 15 times. Retransmissions back off
|
|
exponentially, so these 15 retransmissions take over 900 seconds to complete.
|
|
This means it takes Linux many minutes to detect a network partition or a
|
|
failed node with this method. Windows defaults to just 5 retransmissions which
|
|
corresponds with a timeout of around 6 seconds.
|
|
|
|
The Linux default allows for communication over networks that may experience
|
|
very long periods of packet loss, but this default is excessive for production
|
|
networks within a single data centre as is the case for most {es} clusters.
|
|
Highly-available clusters must be able to detect node failures quickly so that
|
|
they can react promptly by reallocating lost shards, rerouting searches and
|
|
perhaps electing a new master node. Linux users should therefore reduce the
|
|
maximum number of TCP retransmissions.
|
|
|
|
You can decrease the maximum number of TCP retransmissions to `5` by running
|
|
the following command as `root`. Five retransmissions corresponds with a
|
|
timeout of around six seconds.
|
|
|
|
[source,sh]
|
|
-------------------------------------
|
|
sysctl -w net.ipv4.tcp_retries2=5
|
|
-------------------------------------
|
|
|
|
To set this value permanently, update the `net.ipv4.tcp_retries2` setting in
|
|
`/etc/sysctl.conf`. To verify after rebooting, run
|
|
`sysctl net.ipv4.tcp_retries2`.
|
|
|
|
{es} also implements its own health checks with timeouts that are much shorter
|
|
than the default retransmission timeout on Linux. However these health checks
|
|
must allow for application-level effects such as garbage collection pauses. We
|
|
do not recommend reducing any timeouts related to these application-level
|
|
health checks.
|
|
|
|
IMPORTANT: This setting applies to all TCP connections and will affect the
|
|
reliability of communication with systems outside your cluster too. If your
|
|
cluster communicates with external systems over an unreliable network then you
|
|
may need to select a higher value for `net.ipv4.tcp_retries2`. For this reason,
|
|
{es} does not adjust this setting automatically.
|