2.0 KiB
Dead Letter Example
To run the example, simply type mvn verify from this directory, or mvn -PnoServer verify if you want to start and create the broker manually.
This example shows you how to define and deal with dead letter messages.
Messages can be delivered unsuccessfully (e.g. if the transacted session used to consume them is rolled back). Such a message goes back to the JMS destination ready to be redelivered. However, this means it is possible for a message to be delivered again and again without any success and remain in the destination, clogging the system.
To prevent this, messaging systems define dead letter messages: after a specified unsuccessful delivery attempts, the message is removed from the destination and instead routed to a dead letter address where they can be consumed for further investigation.
The example will show how to configure ActiveMQ Artemis to route a message to a dead letter address after 3 unsuccessful delivery attempts.
The example will send 1 message to a queue. We will deliver the message 3 times and rollback the session every time.
On the 4th attempt, there won't be any message to consume: it will have been moved to a dead letter address.
We will then consume this dead letter message.
Example setup
Dead letter addresses and maximum delivery attempts are defined in the configuration file broker.xml:
<address-setting match="exampleQueue">
<dead-letter-address>deadLetterQueue</dead-letter-address>
<max-delivery-attempts>3</max-delivery-attempts>
</address-setting>
This configuration will moved dead letter messages from exampleQueue to the deadLetterQueue.
ActiveMQ Artemis allows to specify either an address or a queue. In this example, we will use a queue to hold the dead letter messages.
The maximum attempts of delivery is 3. Once this figure is reached, a message is considered a dead letter message and is moved to the deadLetterQueue.